![]() Strictly Necessary Cookies: (Always Active) These cookies are necessary for the website to function and cannot be switched off in our systems. After we finish updating our website, you will be able to set your cookie preferences. Protect your Designs with Low-Emissions USB 2.Analog Devices is in the process of updating our website. 고속 USB 아이솔레이터의 이퀄라이저 설정을 이용해 채널 손실을 보상합니다Ĭompensate for Channel Loss with Equalizer Settings on High-Speed USB Isolators How to implement an isolated USB 2.0 high speed, Type-C® DRP VDE Certificate for Reinforced Isolation for DIN EN IEC 60747-17 (Rev. UL Certificate of Compliance File E181974 Vol 4 Sec 6 (Rev. TUV Certificate for Isolation Devices (Rev. VDE Certificate for Basic Isolation for DIN EN IEC 60747-17 (Rev. USB Audio Isolation with Isolated USB 2.0 RedriverĬSA Certificate for ISOUSB211xDP (Rev. ISOUSB211DPEVM EU Electromagnetic Compatibility and RoHS DoC (Rev. Implementing an isolated USB2.0 On-the-go (OTG) port ISOUSB211 High/Full/Low Speed Isolated USB Repeater datasheet (Rev. The device is available in the small foot-print SSOP-28 (28-DP) package. It supports a wide ambient temperature range of –40☌ to +125☌. The ISOUSB211 device is available for reinforced isolation. Used in conjunction with isolated power supplies, the device protects against high voltage, and prevents noise currents from the bus from entering the local ground. This device uses a silicon dioxide (SiO 2) insulation barrier with a withstand voltage of up to 5000 V RMS and a working voltage of 1500 V RMS. The ISOUSB211 has inbuilt programmable equalization to cancel signal loss caused by board traces, which helps in meeting USB2.0 high-speed TX and RX eye-diagram templates. This feature enables the device to support USB On-The-Go (OTG) and Type-C Dual Role Port (DRP) implementations. The device also supports automatic role reversal - if after disconnect, a new connect is detected on the Upstream facing port, then the Upstream and Downstream port definitions are reversed. The device supports automatic connect and speed detection, reflection of pull-ups/pull-downs, and link power management allowing drop-in USB hub, host, peripheral and cable isolation. ISOUSB211 is a galvanically-isolated USB 2.0 compliant repeater supporting low speed (1.5 Mbps), full speed (12 Mbps) and high speed (480 Mbps) signaling rates. 5000-V RMS isolation for 1 minute per UL 1577.Ambient temperature range: –40☌ to +125☌. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |